Mars Express mission controllers ready for NASA Phoenix landing

The Mars Express mission control team have completed major preparations for supporting the entry, descent and landing (EDL) phase of NASA's Phoenix mission to the Red Planet. On 25 May, Mars Express will point towards Phoenix's planned entry trajectory and record signals broadcast from the lander as it plunges through the Martian atmosphere.

The recorded data will serve as a useful and potentially crucial back-up to compare Phoenix's planned and actual descent profiles. Landing is planned for 23:38 UTC, 25 May, which is 01:38 CEST, 26 May.

"We have tested a specially designed slew for our spacecraft, and scheduled a series of data downloads immediately after Phoenix's landing; NASA will receive our recorded data about one hour later," says Michel Denis, Spacecraft Operations Manager at ESOC, ESA's Space Operations Centre, Darmstadt, Germany.

The Mars Express team will monitor the event from the Dedicated Control Room at ESOC.

Effective reuse of on-board lander communications system

Mission controllers will use the MELACOM (Mars Express Lander Communications) system to point towards Phoenix during EDL; the radio instrument was originally intended for communications with the Beagle 2 lander.

Mars Express will perform a high-speed slew as MELACOM tracks Phoenix, rotating about one axis at a speed some two to three times faster than normal; this action has already been tested and confirmed. The orbit phasing of Mars Express was already adjusted at the end of 2007 to provide visibility to Phoenix.

Data recording is scheduled to begin at 23:21 UTC, and run for 26 minutes, until 23:47 UTC.

"Our MELACOM data will enable NASA to confirm the Phoenix lander's descent characteristics, including speed and acceleration through the Mars atmosphere," says Peter Schmitz, Deputy Spacecraft Operations Manager and project lead for Mars Express Phoenix support activities.

MELACOM data will be downloaded to Earth via NASA's Deep Space terminals DSS-15 and DSS-25. After a 15-minute, 20-second light-speed travel time, ESOC will receive the data transmitted from Mars Express, i.e. at 00:40 UTC ( 02:40 CEST). Recorded data will subsequently be downloaded two more times to ensure no loss of packets.

The ESA spacecraft will also fly over Phoenix's intended landing zone, beginning at 06:12 UTC (08:12 CEST) on 26 May and will again monitor signals transmitted up from the surface.

In the following week, Mars Express will monitor Phoenix using MELACOM 14 more times; at least one of these will be used to demonstrate and confirm that the ESA spacecraft can be used as a data relay station for NASA, receiving data from the surface and transmitting test commands to the lander.

This capability has already been trialed between Mars Express and NASA's Mars Exploration Rovers (MER), now operating on the surface.

In the days leading up to the Phoenix landing, NASA and ESA ground stations also cooperated to perform highly sophisticated 'delta-DOR' (delta - Differential One-way Range) interferometry measurements. This enabled a precise determination of whether Phoenix was on track to meet the planned entry point.

This is the first time that ESA has been requested to operationally support NASA with the delta-DOR equipment installed at the Agency's two deep-space tracking stations, in Cebreros, Spain, and New Norcia, Australia.